Wybron Transition Optic - Manual (Page 12)

12
DMX / RDM Setup and Operation
Controls and Indicators
Transition controls and indicators as follows:
o A three character seven-segment display
o 4 push buttons: Menu, (+), (-), and Enter
o Power (red) and signal (green) indicator LED’s
The seven-segment display shows the address number (1-508) and
the Demo mode (OFF, d1, d2). It also displays any error messages
that are covered in the service section of the manual.
The Menu button allows the user to switch between address and demo
mode selection.
The (+) button allows you to increment Transition’s DMX address when
in the address mode, or select between Demo 1 (d1), Demo 2 (d2),
and Demo Off / DMX control (OFF) in demo mode selection.
The (-) button allows you to decrement Transition’s DMX address
when in address mode, or select between Demo 1 (d1), Demo 2 (d2),
and Demo Off / DMX control (OFF) in demo mode selection.
The Enter button allows you to accept the mode or address currently
displayed. Changes are saved in non-volatile memory when the Enter
button is pressed.
The red power indicator LED remains lit when the device is powered.
The green signal indicator LED flashes when a DMX or DMX/RDM
signal is present. It turns off 60 seconds after the last button press.