Wybron Transition Optic - Manual (Page 15)

15
Service
Lamp Replacement
DANGER: Disconnect fixture from line voltage before replacing
lamp.
WARNING: Lamp and lamp mounting surfaces are hot! Allow lamp to
cool before replacing.
 Disconnect fixture from AC power.
 Remove lamp plate by removing mounting screws as shown in figure
1.1 and pull lamp assembly straight back from reflector.
 Grasping lamp by the base remove old lamp from the socket.
CAUTION: Touching the glass lamp envelope can reduce lamp life.
Handle new lamps with a clean cloth. Fingerprints can be
cleaned off lamp envelope with alcohol and a clean cloth.
 Insert new lamp into base. Lamp is fully seated when spring clips snap
over lamp base.
Cleaning the Reflector
WARNING: To avoid burns or damage to the fixture, allow fixture to
cool before cleaning.
 Remove Transition lid.
 Remove lamp plate by removing mounting screws as shown in figure
1.2 and pull lamp assembly straight back from reflector.
 Remove top two reflector mount screws and washers.
 Lift reflector up and back to remove from fixture.
 Use clean pressurized air or a soft cloth with alcohol to clean the
reflective surface.
 Reseat the reflector and secure in place by replacing the top screws
and washers.
 Replace lamp plate and lid.
CAUTION: Harsh chemicals and rough cloth can damage the cold
mirror coating on the reflector. Replace damaged
reflectors.