Waves EQ Sampling System Q-Clone - Manual (Page 21)

D. Add – By clicking the “Add” button you can load a new preset on
top of an existing one. The “Add” mode gives the effect of having 2 or
more EQ devices in a chain. There are 2 options for Add mode:
i. Open a Q-clone preset (from the Q-Clone preset menu or any
directory on your hard drive) or use the existing displayed EQ
curve. Click the “Add” button, and then make changes to it. Note
that changes should be done from a flat EQ starting point.
ii. Load an EQ on top of the existing Q-Clone EQ curve on your
screen. This preset can be loaded from the Q-Clone preset
menu or from any directory on your hard drive.
17. You can use saved presets and factory presets in two ways: Load and
Add. When you click the “Load” button (on the Waves menu bar) you can
choose any preset from the preset list. Each preset will show you two options
for loading. Load will allow you to upload the preset and use it instead of the
one that you had before. Add will upload the preset on top of the one that you
previously used.
Sonar 3.x :
1. Connect a cable from one of your audio card output ports into the input
of the EQ device.
2. Connect a cable from the output of the EQ device to your audio card
input port.
3. Set all of the frequencies gain knobs on your EQ device to 0 db
and turn any filters off.
4. Open a new Audio track in your session.
5. Set the I/O of this track to match the insert I/O that you used in steps 1
and 2.
6. In the track’s Audio Effects window, insert the Q-Capture (from the
Waves plug-ins list).
Waves Q-Clone Manual 21