Waves EQ Sampling System Q-Clone - Manual (Page 23)

New File”. This saves a preset file to any desired directory on your
computer.
B. Save your EQ to your Waves Preset Menu - Click the “Save”
button on the Waves menu bar and choose “Put Into Preset Menu As…”
This will allow you to load your new preset anytime you open the Waves
Q-Clone preset menu.
C.
Reset – Reset the preset by loading the reset preset file from the
Load menu.
D.
Add – By clicking the “Add” button you can load a new preset on
top of an existing one. The “Add” mode gives the effect of having 2 or
more EQ devices in a chain. There are 2 options for Add mode:
i. Open a Q-clone preset (from the Q-Clone preset menu or any
directory on your hard drive) or use the existing displayed EQ
curve. Click the “Add” button, and then make changes to it. Note
that changes should be done from a flat EQ starting point.
ii. Load an EQ on top of the existing Q-Clone EQ curve on your
screen. This preset can be loaded from the Q-Clone preset menu
or from any directory on your hard drive.
14. You can use saved presets and factory presets in two ways: Load and
Add. When you click the “Load” button (on the Waves menu bar) you
can choose any preset from the preset list. Each preset will show you
two options for loading. Load will allow you to upload the preset and
use it instead of the one that you had before. Add will upload the
preset on top of the one that you previously had used.
Logic Pro 7:
1. Connect a cable from one of your audio card output ports into the input
of the EQ device.
2. Connect a cable from the output of the EQ device to your audio card
input port.
3. Set all of the frequencies gain knobs on your EQ device to 0 db.
4. Open your Audio Card control panel and make sure that this in/out
setting is shown properly in the routing chart.
5. Go to Logic menu bar and open the Audio menu. Choose “Audio
Hardware & Drivers…”. In this dialog box choose the “Drivers” tab and
check the “Software Monitoring” check box (If it is not already
checked).
Waves Q-Clone Manual 23