Yamaha DVR-S150 - Manual (Page 85)

TROUBLESHOOTING
80
If there is any problem with your CinemaStation system, check the following items. If you cannot solve your problem
with the following remedies or if your problem is not listed below, turn off and unplug the CinemaStation, then consult
the nearest authorized YAMAHA dealer or service center.
Troubleshooting
General
Problem Cause Solution
Power turns on but
immediately shuts off The system cable may be connected
improperly. Make sure the system cable is
connected properly. (page 10)
The power cable may be connected
improperly. Make sure the power cable is plugged
into the outlet firmly. (page 17)
The speaker cable may be shorted. Make sure all speaker cables are
connected properly. (page 10)
The CinemaStation may receive a
strong electrical shock such as from a
lightening bolt or excessive static
electricity. Set the CinemaStation to the Standby
mode, then disconnect the power cable.
Wait for about 30 seconds, then connect
the power cable and turn on the
CinemaStation.
The speakers make no
sound The volume may be set to minimum
level. Adjust the volume level. (page 20)
The Mute function may be enabled. Cancel the Mute function. (page 20)
The input source or input setting may
be incorrect. Select the correct input source or input
setting. (pages 19 and 70)
The cables may be connected
improperly. Make sure all cables are connected
properly. (page 9)
The disc loaded into the
CinemaStation may be not
compatible. Make sure you use a disc supported by
the CinemaStation. (page 32)
You are playing a DTS source and
“PCM Only” is selected for “Digital
output” in the On-Screen Menu. Select “All” for “Digital output” in the
On-Screen Menu. (page 30)
The TV shows no picture The cables may be connected
improperly. Make sure all cables are connected
properly. (page 12)
Sound suddenly turns off The Sleep Timer (page 28) might be
set. Turn on the CinemaStation and play the
source again.
Sound is too low on one
side The cables may be connected
improperly. Make sure all cables are connected
properly. (page 9)
Speakers other than the
front ones make no sound You may be listening to stereo
sounds without the sound field effect. Press STEREO to enable the sound
field effect. (page 63)
You may be listening to an audio
source (Dolby Digital or DTS) that
does not contain any special effect
signal. Select another DSP program. (page 26)