SUUNTO Gekko - Manual (Page 52)

50
12. Check that the new lubricated O-ring is in good condition. Put it in the right
position on the battery compartment. Be very careful not to get any dirt on
the o-ring or its sealing surfaces.
13. Carefully press the lid onto the battery compartment with your thumb. It is
better to press down the lid down one side fi rst, this minimizes entrapped
air and it is thus easier to hold down the lid. Make sure that the O-ring is
not at any point protruding out on the edge.
14. Put your other thumb through the locking ring. Press this thumb fi rmly
against the lid and release the other one. Make sure that the lid is pressed
completely down!
15. Turn the locking ring counterclockwise with your free thumb and fi ngers
until it snaps into its locked position.
16. The dive computer should now active it’s timekeeping mode and show time
18:00 [6:00 PM] and date SA 01,01. Activate the instrument. Check that:
· All display segments work.
· The low battery warning is off.
· The buzzer beeps and backlight works.
· All the settings are correct. Reset if necessary.
17. Install the dive computer back into the console or boot and reassemble the
strap. The instrument is now ready for use.
Wrist model:
• Assembling into the boot: First insert the longer strap in its hole in the front
of the boot and then the dive computer into its cavity in the boot starting at
the back end. Then snap also the long strap end of the instrument into the
boot. Stretch the boot as needed.
• Assemble the shorter part of the strap. Use the spring bar tool or small
screwdriver to compress the spring bars. Make sure that the spring bars get
fully seated so they will not come off their holes.
Console model:
• Refi t the dive computer in the console according the instructions of the
console.
CAUTION!
Check after the fi rst dives for possible moisture under the transparent battery
compartment lid, indicating a leak.