Yamaha EX5R - Manual (Page 292)

292
No arpeggiator sound.
● Is each part of the arpeggiator muted? (P. 239)
● Are the settings, Velocity Sensitivity and Velocity Limit appropriate? (P. 166)
● Is the note range for the arpeggiator set appropriately? (P. 161)
● (User arpeggio) Are the sequence data properly recorded? (P. 245)
● (Performance mode) Are the Layer Switch and Arpeggio Switch for the part(s) turned on? (P. 171)
Distorted sounds.
● Are the effect settings appropriate? (P. 105)
● Is the volume level set too loud? (P. 79, 96)
● (AN elements) Are the FM parameter and Sync parameter in ALG, OSC menu (Voice Edit) set
too high? (P. 114)
● (AN elements) Is the Feedback Level in MIX, AMP menu (Voice Edit) set too high? (P. 120)
Small sounds.
● Is the MIDI volume or MIDI expression set too low?
● Are the Velocity Sens/Offset in the Voice Mode Setup (Utility mode) set too low? (P. 271)
● Is the cutoff frequency of the filters set too high/low? (P. 110, 118)
Wrong pitch.
● Is the Master Tune in the Synthesizer Setup (Utility mode) set appropriately? (P. 270)
● Are the pitch related parameters in PARAM, PITCH menu (Voice Edit) set appropriately? (P. 83)
● Is the appropriate tuning system selected from Micro Tuning parameter in SCALE, PITCH menu
(Voice Edit)? (P. 84)
● (AN elements) Is the Sync Pitch parameter in ALG, OSC menu (Voice Edit) set appropriately? (P. 114)
● Is the Pitch Modulation Depth in LFO1, LFO menu (Voice Edit) set too high? (P. 102)
● (Performance) Is the Note Shift for each part in LYR (Layer) set to a value other than 0? (P. 171)
● (Performance) Is the Detune for each part in MIX set to a value other than 0? (P. 171)
Sound is choppy and interrupted.
● Do the total number of notes required to the data exceed the maximum polyphony? (P. 78)
● (User arpeggio) Are the velocity and play effects for the arpeggio set appropriately? (P. 239)
Appendix
Appen./E/qx 5/21/98 11:56 AM Page 292