Yamaha MT4X User Manual
Page 35
33
Recording Functions
User’s Guide
Rehearsal
5)
Press the PLAY key to start playback.
6)
Adjust the channel levels with the channel faders. Set the equalization with the HIGH, MID, and
LOW equalizer controls (
2
). Use the Pan control to adjust the pan position. Set the aux send level
with the AUX SEND controls (
3
). Adjust the auxiliary return levels with the LEVEL controls (
9
).
Set the levels and other parameters of any connected signal processing equipment.
Adjust the record levels on the master recorder.
7)
When you are satisfied with the levels, press the RETURN TO ZERO key to stop the rehearsal and
rewind the tape.
Recording
8)
Insert a tape into the master recorder.
9)
Start recording on the master recorder. Press the PLAY key on the MT4X to start playback.
Check the recording
10)
When the recording is finished, rewind the master recorder and play back the tape.
Note:
You may want to remove any count-ins before you create your master tape. There are several ways
of doing this. One method is to switch (input select key) the track that contains the count-in to the MIC/
LINE position until the count is completed and then switch it to the TAPE. Another method is to set the
MT4X to start playback after the count-in. Use the method that you find most comfortable.
Tip:
You can add a synchronized MIDI part to your mix. See "Synchronized mixdown" on page 39.