Zephyr ES1-E30AB - Manual (Page 6)

NOTE: If this hood replaces another one, please note that the location of the air exhaust
can vary from one manufacturer to another.
5. INSTALL THE ADAPTER/DAMPER
Fold down the foldable flange (C) of the
adapter/damper. This flange must be at 90°
from the remaining flanges. Use the lower
screw holes on each side of the
adapter/damper to assemble it to the back
of hood. See below.
- 6 -
It may be necessary to adjust the
adapter/damper location to the existing wall
discharge opening. Leave the foldable
flange (C) of the adapter/damper as is. Use
the upper screw holes on each side of the
adapter/damper to assemble it to the back
of hood. See below.
H ORIZONTAL DISCHARGE , NEW INSTALLATION H ORIZONTAL DISCHARGE , HOOD REPLACEMENT
4. PREPARE THE HOOD
Remove both filters from the hood.
Disassemble the adaptor/damper (A) from the
hood.
NOTE: The adapter/damper is located inside
the hood. Remove the bottom panel
(B) to access the adapter/damper.
Refer to figure beside.
HO0093
A
B
Punch out the electrical and discharge knock-outs for the chosen opening (vertical on top or
horizontal at the back of the hood). Refer to figure below.
HD0219
V ERTICAL D ISCHARGE H ORIZONTAL D ISCHARGE
HJ0008
C
HJ0009
C