Yamaha HTR-5940 - Manual (Page 42)

38
USING OTHER FEATURES
The “DIRECT STEREO” mode allows sources to bypass
the decoders and DSP processors of this unit so that you
can enjoy pure hi-fi sound from 2-channel PCM and
analog sources.
Set the component selector switch to AMP and
then press DIRECT ST. on the remote control to
select “DIRECT STEREO”.
• To avoid unexpected noise, do not play CDs encoded in DTS
when the “DIRECT STEREO” mode is selected.
• When multi-channel signals (Dolby Digital and DTS) are input,
this unit automatically switches to the corresponding analog
input. When “DTS” is selected as the input mode (see page 33),
no sound will be output.
• No sound will be output from the subwoofer.
• “TONE CONTROL” (see page 31) and “SOUND MENU” (see
page 78) settings (except for speaker level settings) are not
effective.
• The front panel display automatically dims.
y
You can also select the “DIRECT STEREO” mode by pressing
the PROGRAM l / h buttons on the front panel repeatedly.
You can display the format, sampling frequency, channel,
bit rate, and flag data of the current input signal.
1
Press one of the input selector buttons to
select the desired input source.
2
Set the component selector switch to AMP
and then press STRAIGHT on the remote
control to select “STRAIGHT”.
“
3
Press u / d to display the information about
the input signal.
Enjoying pure hi-fi stereo sound
Notes
AMP
SOURCE
TV
DIRECT ST.
8
DIRECT STEREO
Displaying the input source
information
CD
MULTI CH IN
SLEEP
CD-R XM
DVD DTV
MD
CBL
TUNER
V-AUX DVR
EFFECT
STRAIGHT
ENT.
AMP
SOURCE
TV
STRAIGHT
A-E/CAT. A-E/CAT.
ENTER
PRESET/CH