Yamaha CLP-280 - Manual (Page 109)

CLP-280/270 Owner’s Manual
109
Appendix
CLP-280/270: Keyboard Stand Assembly
CAUTION
• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accor-
dance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage.
• Be sure to tighten up all screws upon completing assembly of each unit.
• To disassemble, reverse the assembly sequence given below.
1.
Attach E and F to D.
1-1
Secure D using the four 6 x 25mm long screws.
1-2
Remove the twist tie from the folded pedal
cord. Do not remove the twist tie located next
to the hole.
Don’t discard the twist tie, you’ll need it later in
step 6.
Remove all parts from the box. Confirm that all parts shown in the illustration are provided.
Have a Phillips-head (+) screwdriver ready.
A
B
C
D
E F
Connector panel AC INLET
Styrofoam pads
Take out the styrofoam pads, and place A on top of the pads.
Position the styrofoam pads to protect the connector panel at
the bottom of A and the AC INLET.
6 x 25mm long screws x 4
Pedal cord
6 x 16mm short screws x 6
4 x 14mm thin screws x 8
4 x 20mm tapping screws x 5
4 x 10mm thin screws x 2
Cord holders x 2
Headphone hanger
Side panel protection
(cardboard) pads x 2
AC power cord
(The shape of plug
differs depending
on locale.)
1-2
1-1