Yamaha CLP-280 - Manual (Page 59)

CLP-280/270 Owner’s Manual
59
Basic Operation
Connections
The Clavinova’s [MASTER VOL-
UME] dial setting affects the
input signal from the AUX IN
jacks, but the [REVERB], [CHO-
RUS], and BRILLIANCE [MEL-
LOW] [BRIGHT] (page 27)
settings do not.
If you connect the Clavinova to
a monaural device, use only the
AUX IN [L/L+R] jack.
Use audio cables and adaptor
plugs with no resistance.
5 AUX IN [L/L+R], [R] jacks
The stereo outputs from another instrument can be connected to these jacks,
allowing the sound of an external instrument to be reproduced via the
Clavinova’s speakers. Refer to the diagram below and use audio cables for
connection.
CAUTION
When the Clavinova’s AUX IN jacks are connected to an external device, first
turn on the power to the external device, then to the Clavinova. Reverse this
order when you turn the power off.
When the sound from the AUX
OUT jacks is routed to the AUX
IN jacks, the input sound will be
output from the speaker of the
CLP. The output sound may be
excessively loud and may
cause noise.
6 AUX OUT [L] [R] Pin jacks
These jacks let you connect the Clavinova to your stereo system etc. to play at
higher volumes, or connect a cassette recorder etc. to record your playing. Use
audio cables to make connections as shown in the diagram.
CAUTION
When the Clavinova’s AUX OUT jacks are connected to an external audio sys-
tem, first turn on the power to the Clavinova, then to the external audio system.
Reverse this order when you turn the power off.
When “AuxOutLevel (page 89)” is set to “Fixed,” the sound is output to the
external device at a fixed level and the Clavinova’s [MASTER VOLUME] set-
ting will not affect the sound.
When “AuxOutLevel (page 89)” is set to “Variable,” the Clavinova’s [MASTER
VOLUME] setting will affect the sound that is output from AUX OUT.
TIP
TIP
TIP
AUX IN
audio cable
Tone Generator
AUX OUT
Clavinova
phone plug
(standard)
Plug shape depends on the device.
TIP
Stereo
RCA pin plug RCA pin plug
audio cable
Clavinova
AUX IN AUX OUT