Yamaha CLP-280 - Manual (Page 37)

CLP-280/270 Owner’s Manual
37
Basic Operation
Recording Your Performance
Re-recording a song partially
This section explains how to record part of a song again.
Procedure
1.
Select a recording method.
1-1
Press the [FILE/SONG SETTING] button.
1-2
Press the A [–][+] buttons to display “RecStart” or “RecEnd.”
1-3
Press the D [–][+] buttons to specify how the recording should
start and end.
Starting methods:
Normal: The existing data will be erased after re-recording starts.
FirstKeyOn: Data that exists prior to the point where you start playing a note
will not be erased.
Ending methods:
Replace: The data after the point you stop recording will also be erased.
PunchOut: The data after the point you stop recording will remain.
2.
Pause the song at the beginning of the part you wish
to re-record.
Use the B [–][+] buttons while the playback screen is displayed
to move through the measures or play back the recording and
press the [PLAY/PAUSE] button to locate a point slightly prior to
the beginning of the part you wish to re-record.
If the playback screen is not displayed, press the [SONG SELECT]
button once.
3.
Select a voice or voices for recording, if necessary.
Repeat Step 2 on page 35 if you wish to change the previous
settings.
B
D
NO YES
A
C
MEMORY BAR 009
M-001:NewSong001.MID