Zanussi ZHC 95 ALU - Manual (Page 15)

INSTALLATION INSTRUCTIONS
15
Fitting the hood canopy C to the wall
a) Remove the lower grill and the active charcoal filter if
present (see paragraph on maintenance).
b) Fit the support rod B using the two screws K
(3,5x9,5)provided.
c) Hook the hood canopy C to the eye bolts O fixed in
holes 1.
d) Adjust the support rod B so that it pushes against the
wall.
e) Adjusting position.There are two adjustable hooks at
the rear of the hood, which can be used to adjust its
position as follows:
- Turn the screws L until the position of screws N
coincides with the lower
access holes.
- Turn the screws N to adjust
the vertical and horizontal
position of the hood.
- Lock the screws L to fasten
the hood against the wall.
- Insert the plugs T provided
in the holes giving access to
screws N.
Installation of the chimney A
No matter which type of installation is being used, any wooden shelves in the area where the hood is to be
fitted must first be removed, drilled and later replaced.
A08_08
K
B
S36_09
O
O
O
A08_11
L
T
T
L
N
N
N L
S36_10
B