Yamaha VMX17Y(C) - Manual (Page 48)

6-1
1
2
3
4
5
6
7
8
9
OPERATION AND IMPORTANT RIDING POINTS
EAU15951
Read the Owner’s Manual carefully to
become familiar with all controls. If
there is a control or function you do not
understand, ask your Yamaha dealer.
WARNING
EWA10271
Failure to familiarize yourself with
the controls can lead to loss of con-
trol, which could cause an accident
or injury.
EAU46632
TIP
This model is equipped with:
● a lean angle sensor to stop the en-
gine in case of a turnover. In this
case, the multi-function display in-
dicates error code 30, but this is
not a malfunction. Turn the key to
“OFF” and then to “ON” to clear the
error code. Failing to do so will pre-
vent the engine from starting even
though the engine will crank when
pushing the start switch.
● an engine auto-stop system. The
engine stops automatically if left
idling for 20 minutes. In this case,
the multi-function display indicates
error code 70, but this is not a mal-
function. Push the start switch to
clear the error code and to restart
the engine.
EAU46510
Starting the engine
In order for the ignition circuit cut-off
system to enable starting, one of the
following conditions must be met:
● The transmission is in the neutral
position.
● The transmission is in gear with
the clutch lever pulled and the sid-
estand up.
See page 4-27 for more information.
1. Turn the key to “ON” and make
sure that the engine stop switch is
set to “
”.
The following warning lights
should come on for a few seconds,
then go off.
● Oil level warning light
● Fuel level warning light
● Coolant temperature warning light
● Engine trouble warning light
● ABS warning light
NOTICE
ECA15482
If a warning light does not go off, see
page 4-2 for the corresponding
warning light circuit check.
2. Shift the transmission into the neu-