Zebra Technologies Strata Thermal Printers - Manual (Page 66)

Guidelines Use the cutter to cut through continuous paper
from rolls and liner between labels.
You can switch between cutting and feeding by
using the OC command. You can set form
length and gap distances by using the Q com-
mand. Refer to the EPL2 programmer’s man-
ual for complete programming information.
Keep the cutter dry. Never use any solutions or
solvents to clean the blade. If there is a jam, fol-
low the steps for Clearing the Cutter.
Specifications Cutter warranty 90 days
Blade life 500,000 cuts
Media types Direct thermal paper
Paper label liner
Tag stock
MaximumThickness 0.0075 in. (0.191mm)
Density 150 g/m 2
Width 4.00 - 8.75 in.
(101.6 - 222.25 mm)
Minimum length
using cutter 1.25 in. (31.8 mm)
58
980181-001 Rev.C
Using the Media Cutter