ZyXEL Communications 200 Series - Manual (Page 280)

Chapter 12 Policy and Static Routes
ZyWALL USG 100/200 Series User’s Guide
280
The following table describes the labels in this screen.
Table 89 Network > Routing > Policy Route
LABEL DESCRIPTION
Enable BWM This is a global setting for enabling or disabling bandwidth management on the
ZyWALL. You must enable this setting to have individual policy routes or application
patrol policies apply bandwidth management.
This same setting also appears in the AppPatrol > General screen. Enabling or
disabling it in one screen also enables or disables it in the other screen.
Total
Connection This field displays the total number of policy routes.
connection per
page Select how many entries you want to display on each page.
Page x of x This is the number of the page of entries currently displayed and the total number of
pages of entries. Type a page number to go to or use the arrows to navigate the
pages of entries.
# This is the number of an individual policy route.
User This is the name of the user (group) object from which the packets are sent. any
means all users.
Schedule This is the name of the schedule object. none means the route is active at all times
if enabled.
Incoming This is the interface on which the packets are received.
Source This is the name of the source IP address (group) object. any means all IP
addresses.
Destination This is the name of the destination IP address (group) object. any means all IP
addresses.
Service This is the name of the service object. any means all services.
Next-Hop This is the next hop to which packets are directed. It helps forward packets to their
destinations and can be a router, VPN tunnel, outgoing interface or trunk.
SNAT This is the source IP address that the route uses.
It displays none if the ZyWALL does not perform NAT for this route.
BWM This is the maximum bandwidth allotted to the policy. 0 means there is no bandwidth
limitation for this route.
Add icon Click the Add icon in the heading row to add a new first entry.
The Active icon displays whether the rule is enabled or not. Click the Active icon to
activate or deactivate the policy. Make sure you click Apply to save and apply the
change.
Click the Edit icon to go to the screen where you can edit the routing policy on the
ZyWALL.
Click the Add icon in an entry to add a rule below the current entry.
Click the Remove icon to delete an existing routing policy from the ZyWALL. A
window displays asking you to confirm that you want to delete the routing policy.
In a numbered list, click the Move to N icon to display a field to type a number for
where you want to put that rule and press [ENTER] to move the rule to the number
that you typed.
The ordering of your rules is important as they are applied in order of their
numbering.
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to begin configuring this screen afresh.