ZyXEL Communications 200 Series - Manual (Page 609)

Chapter 36 Addresses
ZyWALL USG 100/200 Series User’s Guide
609
The following table describes the labels in this screen.
36.3 Address Group Summary Screen
The Address Group screen provides a summary of all address groups. To access this screen,
click Object > Address > Address Group.
Figure 452 Object > Address > Address Group
Table 201 Object > Address > Address > Edit
LABEL DESCRIPTION
Name Type the name used to refer to the address. You may use 1-31 alphanumeric
characters, underscores(
_ ), or dashes (-), but the first character cannot be a
number. This value is case-sensitive.
Address Type Select the type of address you want to create. Choices are: HOST, RANGE,
SUBNET, INTERFACE IP, INTERFACE SUBNET, and INTERFACE GATEWAY.
Note: The ZyWALL automatically updates address objects that are
based on an interface’s IP address, subnet, or gateway if the
interface’s IP address settings change. For example, if you
change LAN1’s IP address, the ZyWALL automatically
updates the corresponding interface-based, LAN1 subnet
address object.
IP Address This field is only available if the Address Type is HOST. This field cannot be blank.
Enter the IP address that this address object represents.
Starting IP
Address This field is only available if the Address Type is RANGE. This field cannot be
blank. Enter the beginning of the range of IP addresses that this address object
represents.
Ending IP
Address This field is only available if the Address Type is RANGE. This field cannot be
blank. Enter the end of the range of IP address that this address object represents.
Network This field is only available if the Address Type is SUBNET, in which case this field
cannot be blank. Enter the IP address of the network that this address object
represents.
Netmask This field is only available if the Address Type is SUBNET, in which case this field
cannot be blank. Enter the subnet mask of the network that this address object
represents. Use dotted decimal format.
Interface If you selected INTERFACE IP, INTERFACE SUBNET, or INTERFACE
GATEWAY as the Address Type, use this field to select the interface of the
network that this address object represents.
OK Click OK to save your changes back to the ZyWALL.
Cancel Click Cancel to exit this screen without saving your changes.