Zanussi ZKT 662 LN - Manual (Page 8)

151
Residual heat indicator
An “H” will light up in the power level indicator if the
temperature of the corresponding cooking zone sur-
face above 60°C. When the cooking zone has been
switched off, the lamp remains on until temperature
falls below 60°C.
Pay attention when a pan/pot is left on the coo-
king zone that the residual heat indicator can
switch off though is the cooking zone still hot
from the pan with hot contents.
Operation
The touch controls must be pressed for at least
1 second to be activated, which will be indicated
by an acoustic signal.
Switching the
appliance on
1. Press the hob ON/OFF control (1) for at least 1 se-
cond.
A horizontal line appears in each power level indicator
(3), and the dot (13) flashes.
The next input must take place within the
next 10 seconds, otherwise the hob will
switch off again.
Switching on the
cooking zones
Having switched on the appliance with the hob ON/
OFF control (1), you can now switch on the various
cooking zones within the next 10 seconds.
1. Press the cooking zone control (2) for the required
cooking zone.
«0» lights up on the corresponding power level in-
dicator. At the same time, dot (13) lights up to indi-
cate which cooking zone is active.
2. Select a power level (1--9) using the decrease con-
trols (5/4).
If you selct the power level using the increase
control, the boost facility will be activated (see
pages 66).
The increase/decrease controls (5/4) are
equipped with a repeat function. If one of the
keys is continually pressed, the power level will
be increased.
Only one cooking zone control (2) can be ac-
tive at a time, that is, only one dot (13) can be
lit up.
1
13 3
2
13
4
5