Yamaha DRX-1 EN - Manual (Page 53)

A PPENDIX 49
English
Appendix
Using your DVD Recorder
remote control with your TV
Your DVD Recorder remote control has limited control of
TVs of different brands.
The following buttons will operate TVs:
- VOL + increase TV volume
- VOL - decrease TV volume
- MUTE mute TV sound
Other buttons normally operate the DVD Recorder but
will operate the TV if you press and hold TV SHIFT.
- CH + next higher TV channel
- CH - next lower TV channel
- 0 - 9 choose TV channel directly
- POWER (B/I)
switch TV to standby or power off or on
If your TV does not respond to the Recorder’s remote
control, reprogram your remote control. Below are the
remote control codes for various TV brands. Follow these
steps to reprogram the remote control.
1 Look up the setup code for your TV in the code list in
the following pages.
2 Pointing the remote control at the TV, press and hold
t and u (left and right cursor) simultaneously for at
least three seconds.
3 Release both buttons.
4 Within 30 seconds, enter the correct four digit code
by using the digit buttons 0-9.
5 See if the remote works as described at left. If the
remote does not work your TV, try other codes for
your brand. If the brand of your TV is not in the list,
try the codes for other brands one after the other or
follow the alternative process as described below.