Zephyr ATI-M90ABX - Manual (Page 12)

www.zephyronline.com
Installa
tion - In
ternal Blo
w
e
r
13. Secure Green/Yellow ground wire connected to
the cable to the provided capacitor to blower
plate. (type A) Fig. 11
14. Attach the 6 pin male molex connector from
blower wire to the 6 pin female molex connector
located inside the blower housing. See Fig.12
15. Install the blower and plate on the inside of
the blower housing:
carry out the instruc-
tions at step 3 in re-
verse order then use
the screws provided
to complete installa-
tion.(Tot. 16 type B)
Fig.13
16. Open the fl ap. Con-
nect 9 pin male mo-
lex connector from blower wire to 9 pin
female molex connector on the capacitor
wire. See Fig. 14
WARNING! Place electrical wiring inside the
blower housing.
17. Put the Decortive Mesh Filter back on
and close the front panel while holding
it by its external sides until it shuts; then
put the canopy back on.
The hood is now ready to be instal-
led on the wall.
- 12 -