Zephyr ATI-M90ABX - Manual (Page 18)

www.zephyronline.com
WARNING: In order to facilitate their connection, make sure that the power
supply conduits are not obstructed by the hood.
3. When the hood has been adjusted tighten the screws to secure the hood
in place.
4. Once the adjustment has been completed, fi x the hood defi nitely using
another (2 type D) screws.
NOTE: Screws must be fastened into wooden studs so wood blocking may be
necessary. If using wall anchors make sure to check your local codes for suita-
bility and type of anchors to use.
NOTE1: For the various installations use screws and screw anchors suited to the
type of wall (minimum screw size: 1/4" diameter x 2-3/4" length).
NOTE2: The following Duct Cover kits are available as acessories: Z1C-00TI,
Z1C-01TI
Installa
tion - Moun
ting the R
ange Hood
- 18 -