Yamaha RXV3000RDS - Manual (Page 31)

English
29
AM/FM Tuner
Connecting the Antennas
Both AM and FM indoor antennas are included with this unit. These antennas should provide sufficient signal strength in most situations.
However, a properly installed outdoor antenna provides clearer reception. If you experience poor reception quality using the indoor antennas,
an outdoor antenna may improve the reception.
Connect each antenna as shown below.
L
L
R L R
R
CAUTION SEE INSTRUCTION MANUAL FOR
TUNER
FM ANT
75 Ω
UNBAL.
AM
ANT
– GND
■ Connecting the indoor FM antenna
Connect the included indoor antenna to the 75
Ω
UNBAL.
FM ANT terminal.
■ Optional outdoor FM/AM antenna
Consult your dealer or authorized service center about the
best method of selecting and erecting outdoor antennas.
■ Connecting the AM loop antenna
1 1 Press the tab to unlock the terminal hole.
2 2 Insert the AM loop antenna lead wires to the AM ANT and GND terminals.
3 3 Lift the tab to its original position to lock the lead wires.
Lightly pull on the lead wires to confirm a good connection.
4 4 Attach the loop antenna to the antenna stand.
5 5 Orient the AM loop antenna so that the best reception is obtained.
Notes:
• The AM loop antenna should be placed away from this unit. The antenna may be
hung on a wall.
• The AM loop antenna should remain connected, even if an outdoor AM antenna is
connected to this unit.
• To minimize the influence of automobile ignition noise, locate the antenna as far
from heavy traffic as possible.
• Keep the ribbon cable or coaxial cable as short as possible.
Do not bundle or roll up excess cable.
• The antenna should be at least 1.8m (6 feet) from reinforced concrete walls and
metallic structures.
Indoor FM antenna (included) AM loop antenna (included)
Ground
1
3
2
Loop Antenna
Antenna stand