Zebra Technologies S400 - Manual (Page 20)

12 Zebra S400 & S600 User’s Guide
9. Adjust all of the guides:
• Push the media supply guide inward until it is just touching the
outer side of the media supply roll, then lock the guide in place with
its locking screw. The guide must not cause pressure or excessive
drag on the media supply roll.
• Adjust the outer edge guides on both the lower guide rod and the
platen guide rod until they just touch the outer edge of the media
and backing without causing the material to buckle.
• Adjust the media guide until it just touches the outer edge of the
media without causing the material to buckle.
10. See “Adjusting the Media Sensor” on page 18 to adjust the media
sensor.
NOTE: In the Peel-Off mode, proper media tracking is critical.
Refer to “Backing Rewind Power Roller Adjustment” on page 42
to make sure that the media tracks properly through the printer.
Figure 9. Loading — Peel-Off Mode