Yamaha GX-900 - Manual (Page 14)

6
Preparations and connections
Ⅵ
Connecting external components
This system can be connected with external audio
components.
● Connect an audio component to the AUX terminals on the
rear of the main unit by using RCA pin plug connector
cables correctly, that is to say L (left) to L and R (right) to R.
Also, refer to the owner’s manual for the component to be
connected to this system.
If a tape deck is connected to the AUX (OUT) terminals, a
source played on this system or radio program can be
recorded with the tape deck.
● A digital-to-digital recording is possible from an external LD
(DVD) player, satellite tuner, DAT, etc. connected to the
DIGITAL IN (OPTICAL) terminal on the rear of the main unit
to the built-in MD recorder.
Ⅵ
Antenna connection
(1) Supplied FM antenna
Connect the FM antenna wire to the corresponding terminal
and direct the FM antenna wire to the direction where the
strongest signal can be received.
(2) Supplied AM loop antenna
Connect the AM loop antenna wires to the corresponding
terminals. Position the AM loop antenna for optimum
reception.
Notes
●
When static is still heard even after adjusting the position of
the AM loop antenna, try reversing the wire connections
(from the right terminal to the left one, and vice versa).
●
The AM loop antenna should be placed apart from the main
unit. The antenna may be hung on a wall.
Using an external antenna
● Use an external FM antenna instead of an indoor FM
antenna if you need better reception. Consult your dealer.
●
Use an external AM antenna if you need better reception.
Consult your dealer.
(1)
(2)
ANTENNA
75 Ω UNBAL.
FM GND AM
ANTENNA
75 Ω UNBAL.
FM GND AM
DIGITAL IN OPTICAL
ANTENNA
75 Ω UNBAL.
FM GND AM
OUT
SUBWOOFER
R L
ANTENNA
75 Ω UNBAL.
FM GND AM
DIGITAL IN
OPTICAL
R L
OUT
IN
SEE OWNE
FOR CONN
FRONT
SPEAKERS
8 Ω MIN./
AUX
DIGITAL OUT
IN OUT
Tape deck, etc.
DVD player, etc.