Yamaha CDR-HD1500HDD - Manual (Page 80)

74
SYSTEM UTILITY
■ Setting the display brightness
(Dimmer Setup)
You can change the brightness of the display.
1.
Carry out steps 1 to 3 in “Checking the firmware
version (Firm. Version)” (P.73).
The display changes for the system utility item selection.
2.
Rotate the MULTI JOG knob (press +/–, H or G on the
remote control) to select “Dimmer Setup”.
3.
Press the MULTI JOG knob (ENTER on the remote
control) to display the current setting.
Rotating the MULTI JOG knob (pressing +/–, H or G on the
remote control) changes the setting as follows.
Memo
Initial setting is “Dimmer Bright”.
4.
Press the MULTI JOG knob (ENTER on the remote
control) or COMPLETE.
The display brightness has been set.
5.
Press a or MENU to exit.
The unit returns to the stop mode.
D i m m e r S e t u p
L
R dB –30 –10 –6 –2 0
D i m m e r B r i g h t
L
R dB –30 –10 –6 –2 0
D i m m e r M i d
L
R dB –30 –10 –6 –2 0
D i m m e r D a r k
L
R
dB –30 –10 –6 –2 0
■ Setting the video output
(VIDEO Output)
You can switch the on-screen display output through the VIDEO
OUT jacks on and off.
1.
Carry out steps 1 to 3 in “Checking the firmware
version (Firm. Version)” (P.73).
The display changes for the system utility item selection.
2.
Rotate the MULTI JOG knob (press +/–, H or G on the
remote control) to select “VIDEO Output”.
3.
Press the MULTI JOG knob (ENTER on the remote
control) to display the current setting.
Rotating the MULTI JOG knob (pressing +/–, H or G on the
remote control) switches the setting between “VIDEO On” and
“VIDEO Off”.
Memo
Initial setting is “VIDEO On”.
4.
Press the MULTI JOG knob (ENTER on the remote
control) or COMPLETE.
The on-screen display output is set to on or off.
Memo
Select “VIDEO Off” if the on-screen display is not used so that you
can enjoy playback or recording with higher quality sounds.
5.
Press a or MENU to exit.
The unit returns to the stop mode.
V I D E O O u t p u t
L
R dB –30 –10 –6 –2 0
107_HD1500(E)71-75.p65 3/20/05, 12:43 74