Zanussi ZHC 916X - Manual (Page 17)

17
E E
E
E
B
Fixing the chimney
a) Loosen the screws M fixing the two parts of the
chimney and pull the inner section I (Fig. 21)
almost all the way out. Remove the protective film
P.
b) Rest the lower section of the chimney in its housing
on the top of the hood canopy. Lower the ducting
fan unit until it reaches the wall bracket S and fix
it using the screw H provided (Fig. 22).
Fit cover D provided on the wall bracket S (Fig.
23).
c) Fix the chimney A to the hood canopy C using
four screws provided (Fig. 24).
d) Insert the transparent seal Q provided, so as to
eliminate any play between the two parts of the
chimney (Fig. 25). Lock the screws M.
e) Remove the support rod B.
Ducting or re-circulation fitting
1. Ducting fitting:
This is possible in all forms of installation.
a) Connect the air outlet to the external ducting
system.
b) Remove the activated charcoal filter (if fitted)
inside the hood canopy (See Maintenance and
Cleaning).
2. Re-circulation fitting:
This is only possible with the air outlet directed
upwards. Fit the venting grille G onto the air outlet
(Fig. 26). The activated charcoal filter should be
fitted inside the hood canopy after connection.
INSTALLATION INSTRUCTIONS
21
A08_20
M
I
P
22
A08_21
S
S
H
23
A08_22
D
24
25
A08_24
Q Q
26