Yamaha RP-U200 - Manual (Page 45)

E-
7
CONNECTIONS
CONNECTIONS
R L
ANALOG
AUX 1
IN
AUX 2
IN
REC
OUT
OUTPUT
SUB
WOOFER
DIGITAL
USB
SPEAKERS
+ –
L
FRONT
ANTENNA
R L
PC IN
FM ANT
75 Ω UNBAL.
SUPERWOOFER SYSTEM YST-SW45
HIGH CUT STANDBY/ON
150Hz 50Hz
VOLUME
10 0
LINE IN
Subwoofer
Adding a subwoofer
It is recommended to connect a subwoofer to this unit to
enhance the bass performance of your system and
reproduce surround sounds of Dolby Digital, DTS and
CINEMA DSP effectively.
Notes
● The SUBWOOFER OUTPUT is a line-level output. Use a
subwoofer which has its own built-in power amplifier,
such as the Yamaha YST-SW45.
● If no sound is reprodced from the subwoofer, check the
“Speaker Settings” in the Application Software. Refer to
page 27 of the separate “OPERATION MANUAL” for
details.
10 mm
➁
➂ ➀
Speaker Cables
Strip 10 mm of insulation off the end of each speaker
cable, and then twist the bare wires to prevent lose
strands, which can cause short circuits. How to connect:
1 Press and hold the speaker connector levers.
2 Insert the bare ends of the speaker cables into the
terminal holes.
3 Then release the levers.
* Try pulling gently on each cable to make sure that it is
secure.
(U.S.A. model)