Zebra Technologies R110Xi - Manual (Page 177)

Index
23063L-003 Rev. 1 12/6/04 R110Xi/R170Xi User Guide 165
H
HEAD COLD message, 129
HEAD ELEMENT BAD message, 127
HEAD OPEN message, 127
HEAD TOO HOT message, 128
host handshake setting, 51
host verification command (^HV), 80
I
idle display setting, 59
image not sharp, 130
images list, 48
initialize Flash memory, 49
inspect the printer, 9
interior cleaning, 117
international safety organization marks, 11
IP settings
default gateway, 61
IP address, 60
protocol, 60
subnet mask, 60
ISO18000 transponder characteristics, 68
L
label formats for RFID, 69
label length maximum setting, 46
label specifications by model, 148
label top
printer cannot detect, 133
setting, 55
label-available sensor
location, 119
when to clean, 116
labels did not print, 132
labels per roll setting, 47
language selection, 59
LCD messages
adjust LCD settings, 58
error messages, 127
language selection, 59
setup mode, 44
liability, 152
light or no printing, 130
lights on front panel, 5
list settings
all settings, 48
bar codes, 47
fonts, 47
formats, 48
images, 48
setup, 48
load the printer
load fanfold media, 24
load roll media, 21
ribbon, 26
long calibration, 35
lower media sensor adjustment, 38
M
MAC address, 61
mark LED setting, 58
Mark Med S. setting, 58
maximum label length setting, 46
media
continuous roll media, 14
fanfold, 15
label specifications by model, 148
load fanfold media, 24
load roll media, 21
media LED setting, 58
media low warning, 47
non-continuous roll media, 14
RFID “smart” labels, 15
setting labels per roll, 47
setting media type, 45
types of media, 14
media and ribbon sensor calibration
procedure, 50
media path cleaning, 116
media power up setting, 54
Media S. setting, 58
media scratch test, 16
media sensor
adjustments, 37
location, 120
print media sensor profile, 49
sensor sensitivity calibration, 36
memory card installation
CompactFlash card, 112
PCMCIA memory card, 110
modem connection, 105
motion in RFID label, 85