Zebra Technologies R110Xi User Manual
Page 58
46
R110Xi/R170Xi User Guide
23063L-003 Rev. 1 12/6/04
Front Panel Controls
Front Panel LCD
PRINT METHOD
Selecting Print Method
The print method parameter tells the printer the method of printing that you wish to
use: direct thermal (no ribbon) or thermal transfer (using thermal transfer media and
ribbon).
• Press either oval to display choices.
Default: THERMAL-TRANS.
Selections: THERMAL-TRANS., DIRECT-THERMAL
Note •
Selecting direct thermal when using thermal transfer media and ribbon
creates a printer error condition, but printing continues.
PRINT WIDTH
Setting Print Width
Print width determines the printable area across the width of the label.
To change value shown:
1.
Press the left oval to move the cursor.
2.
Press the right oval to increase the value of the digit.
Note •
The printer does not accept any value larger than the maximum print width
General Specifications on page 144
.
To change the unit of measurement:
a.
Press the left oval until the unit of measurement is active.
b.
Press the right oval to toggle to a different unit of measure (mm, inches,
or dots).
Default Range:
The default and range of acceptable values vary depending on the
General Specifications on page 144
for further information about the
ranges available for your model.
MAXIMUM LENGTH
Setting Maximum Length
Maximum length is used in conjunction with the calibration procedure. The value
of this setting is the maximum label length that is used during the media portion of
the calibration process. Only a few labels are required to set media sensors. Always
set the value that is at least 1 in. (25.4 mm) longer than the longest label to be used
on the printer.
• To increase the value, press the right oval.
• To decrease the value, press the left oval.
Default Range:
The default and range of acceptable values vary depending on your
printer’s configuration. Values are adjustable in 1 in. (25.4 mm) increments.
Table 7 • Standard LCD Displays (Page 3 of 16)
Parameter
Action/Explanation