Xerox 4220/MRP - Manual (Page 50)

ADMINISTERING THE FAX SOFTWARE
2. Select the Print Fax Printer Settings Page on the Advanced
Installation Options screen.
3. Press Enter.
The Fax Printer Settings Page (showing your current settings)
prints from the default input tray and paper size.
Follow these steps to change the internal fax printer settings:
1. Select Edit Fax Printer Settings on the Advanced Installation
Options screen and press Enter.
The Edit Fax Printer Settings screen appears.
2. Select the fax printer settings to change.
On the bottom left side of the screen a message appears
telling you how to change the highlighted setting. Some
settings require that you enter in a new value, while others
request you to press Enter to display a menu of choices.
3. Press F10 when you are finished changing fax printer settings.
The following sections provide information on each of the fax
printer settings.
Number of rings before answer (1-5)
The default setting for the Number of Rings Before Answer is 2,
(two rings). You can enter a number from 1 to 5 to change this
setting.
If the line is for fax only, make this value small. If you are using a
telephone on the same line for voice communication, set this
value higher so that you have time to pick up the line before the
printer does so.
N Note: The fax utility cannot set the number of rings
before answering to more than 5. However, the printer
control panel allows you to set this figure from 1 through
10. If you need to set the number of rings before
answering to more than 5, follow the procedure in the
“Receive Setup” section in the “Fax Setup menu”
chapter.
3-4 XEROX MRP FAMILY FAX MODEM FOR MS-DOS OPERATOR GUIDE