Znyx Networks bh5700 - Manual (Page 34)

#start_script:/etc/rcZ.d/SxxScript;
#start_script:/etc/rcZ.d/SyyScript;
# vrrpd_script: Allows the user to add scripts to be executed
during
# vrrpd state transitions. These scripts are run from the end
of the
# /etc/rcZ.d/surviving_partner/vrrpd.script file. The user
provided
# script must be well behaved. If it crashes, or hangs or
delays it will
# effect the SurvivingPartner performance. The script is not
run in
# backround. If this is needed, have your script background
itself.
#vrrpd_script: /etc/rcZ.d/surviving_partner/my_vrrpd_script;
#vrrpd_script: /etc/rcZ.d/surviving_partner/my_vrrpd_script2;
# gated_template: Allows the user to provide a template for
the
# gated.conf file to be used by the sibling group.
#gated_template: /etc/rcZ.d/surviving_partner/gated.template
These entries are optional:
If you use the special failover modes vlan or port ( see above for details), you can also specify an
individual address to be the default master, that is, that a port or VLAN should run on a specific
switch when the vrrp priorities are equal between switches.
NOTE: VLAN or port mastering is not appropriate for switch mode and should not be
attempted.
When addresses designated 'master' failover, they will return to their Master switch, whenever the
link is repaired. If they are not designated 'master', they will remain at the backup switch after
repairs.
If both switches are equal in priority for a VLAN, then the switch with theIPaddress designated
'master' will become Master for that VLAN.
Add the keyword “(master)” after one of the sibling_addresses. The local address comes first.
sibling_addresses: zhp1=10.0.0.30(master), 10.0.0.31
netmask 255.0.0.0;
Ethernet Switch Blade User's Guide release 3.2.2j page 34