Znyx Networks bh5700 - Manual (Page 38)

vrrp_virtual_address: zhp1 = 10.0.0.42 netmask 255.0.0.0;
vrrp_virtual_address: zhp2 = 11.0.0.42 netmask 255.0.0.0;
vrrp_virtual_address: zhp3 = 12.0.0.42 netmask 255.0.0.0;
vrrp_virtual_address: zhp4 = 13.0.0.42 netmask 255.0.0.0;
# Port definitions
# Define to what the ports are connected. Specifications can
be
# by zhp or zre name. The zhp name is a shortcut to specify
the
# entire port group associated with that interface. In the end
# these definitions are on a port by port basis. Note: zhp and
# zre names cannot be mixed on the same line.
#
# Shelf manager ports should be defined as monitor_only.
monitor_only ports
# are used in failover calculations, but the failover mechanism
is left
# to the software running on the shelf managers cards. The use
of the
# term "crossconnect" in these HA scripts is not the same as
the use
# in ATCA shelf managers.
interconnect: zhp0;
RAINlink: zre0..19, zre24..43;
############################# Special Modes
#############################
# VRRP modes
# The block_crossconnect mode causes the equivalent of STP
blocking on the
Ethernet Switch Blade User's Guide release 3.2.2j page 38