Zanussi ZSF2450 - Manual (Page 11)

2. Set a new washing programme .
Fill the detergent dispenser with detergent be-
fore you set a new washing programme.
Interrupting a washing programme
Open the door.
• The programme stops.
Close the door.
• The programme continues from the point of
interruption.
Setting and starting a washing programme
with delay start
1. Press the on/off button.
2. Set a washing programme.
3. Press the delay start button until the display
shows on flashing the necessary delay start of
the washing programme.
– The delay start indicator light comes on.
4. Close the door.
– The number on the display comes on with
fixed light.
– The countdown of the delay start starts.
– The countdown of the delay start decrea-
ses with steps of 1 hour.
– When the countdown is completed, the
washing programme starts automatically.
Do not open the door during the count-
down to prevent interruption of the count-
down. When you close the door again, the count-
down continues from the point of interruption.
Cancelling a delay start:
1. Press and hold function buttons B and C until
all the programme lights come on.
– When you cancel a delay start, you also
cancel the washing programme.
2. Set a new washing programme.
You can select the washing programme and
delay start also with the door closed. When
you press a programme button you have only 3
seconds to select a different washing programme
or a delay start. After these 3 seconds, the selec-
ted programme starts automatically.
End of the washing programme
Switch off the appliance in these conditions:
• The appliance stops automatically.
• The display shows 0.
• The end of programme indicator comes on.
1. Press the on/off button.
2. Open the door.
3. For better drying results, keep the door ajar
for some minutes before you remove the
dishes.
Let the dishes cool down before you remove
them from the appliance. Hot dishes are easily
damaged.
Standby mode
If you do not switch off the appliance at the end
of the washing programme, the appliance auto-
matically goes into standby mode. The standby
mode decreases energy consumption.
Three minutes after the end of the programme,
all indicator lights go off and the digital display
shows one horizontal bar.
Press one of the buttons (not the on/off button),
to go back to end-of-programme mode.
Care and cleaning
Warning! Switch the appliance off before
you clean it.
Cleaning the filters
Important! Do not use the appliance without the
filters. Make sure that the installation of the
filters is correct. Incorrect installation will cause
unsatisfactory washing results and damage to the
appliance.
11