What to do if – Zanussi ZSF2450 User Manual

Page 13

Advertising
background image

What to do if…

The appliance does not start or stops during op-
eration.
If there is a fault, first try to find a solution to the
problem yourself. If you cannot find a solution to

the problem yourself, contact your dealer or the
Service Force Centre.

Fault code and malfunction

Possible cause and solution

• digital display shows
The dishwasher does not fill with
water

• The water tap is blocked or furred with limescale.

Clean the water tap.

• The water tap is closed.

Open the water tap.

• The filter in the water inlet hose is blocked.

Clean the filter.

• The connection of the water inlet hose is not correct. The

hose can be kinked or squashed.
Make sure that the connection is correct.

• digital display shows
The dishwasher will not drain

• There is a blockage in the sink spigot.

Clean the sink spigot.

• The connection of the water drain hose is not correct. The

hose can be kinked or squashed.
Make sure that the connection is correct.

• the drain pump operates contin-

uously

• all indicators lights on the control

panel go off

The anti-flood device operates

• Close the water tap and contact your local Service Force

Centre.

The programme does not start

• The appliance door is not closed.

Close the door.

• Mains plug is not connected in.

Put in the mains.

• The fuse has blown out in the household fuse box.

Replace the fuse.

• Delay start is set.

Cancel the delay start to start the programme immediately.

After the check, switch on the appliance. The
programme continues from the point of inter-
ruption. If the malfunction shows again, contact
your Service Force Centre.
These data are necessary to help you quickly and
correctly:
• Model (Mod.)

• Product number (PNC)
• Serial number (S.N.)
For these data, refer to the rating plate.
Write the necessary data here:
Model description : ..........
Product number : ..........
Serial number : ..........

13

Advertising