Zanussi ZSF2450 - Manual (Page 16)

If the water inlet hose is too short, replace the
water inlet hose with an applicable, longer high-
pressure hose. Do not connect an extension hose.
To suit the installation, it is possible to turn the
end of the hose that is connected to the dish-
washer. Do these steps :
Connect the inlet hose
to a water tap with an
external thread of
3/4”.
1. Loosen the retain-
ing nut.
2. Turn the hose.
3. Tighten the retain-
ing nut.
Warning! Make sure that the retaining nut
and all other connections are tight before
you move the dishwasher into position.
Warning! Always use a new water inlet hose.
Do not use connection hoses from an old
appliance.
Drain hose
The appliance has water safety system to
prevent water damage. If there is a malfunc-
tion, the drain pump automatically starts to drain
the remaining water out of the dishwasher.
Warning! Only if the dishwasher is
connected to the mains socket, the water safety
system operates when the dishwasher is off.
Two procedures are possible to install the water
drain hose :
2
1
max. 75cm
1. Attach the plastic curve supplied at the end
of the hose.
Put the water drain hose in the sink.
2. Connect the water drain hose to the water
drain system.
The hose must be less than 75 cm above the
bottom of the dishwasher to prevent in-
correct operation of appliance.
If you connect the wa-
ter drain hose to a trap
spigot under the sink,
remove the plastic
membrane (A). If you
do not remove the
membrane, remaining
food can cause a
blockage in the drain
hose spigot
Electrical connection
Warning! The manufacturer is not
responsible if you do not follow these safety
precautions.
Ground the appliance according to safety
precautions.
Make sure that the rated voltage and type of
power on the rating plate agree with the voltage
and the power of the local power supply.
Always use a correctly installed shockproof
socket.
Do not use multi-way plugs, connectors and
extension cables. There is a risk of fire.
Do not replace the mains cable yourself. Contact
the Service Force Centre.
Make sure that the mains plug is accessible after
installation.
Do not pull the mains cable to disconnect the
appliance. Always pull the mains plug.
16