Yamaha CC-75 - Manual (Page 11)

E-3
English
CAUTION FOR CARRYING THIS UNIT
Be sure not to carry or tip this unit with discs remaining in it.
CAUTION FOR MOVING THIS UNIT
Before moving this unit, first remove all discs from the disc table
and close the table by pressing the OPEN/CLOSE button, and
then switch off the power by pressing the POWER switch, and
last, after you confirm that “no disc” is illuminated on the display,
disconnect the power plug from the AC outlet.
SETTING UP THE SYSTEM
CAUTION 1
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous
radiation exposure.
CAUTION 2
As the laser beam used in this unit is harmful to the eyes, do not
attempt to disassemble the cabinet. Refer servicing to qualified
personnel only.
Laser component in this product is capable of emitting radiation
exceeding the limit for Class 1.
PRECAUTIONS: READ THIS BEFORE OPERATING YOUR UNIT
WARNING
To reduce the risk of fire or electric shock, do not expose this unit to
rain or moisture.
To avoid electrical shock, do not open the cabinet. Refer
servicing to qualified personnel only.
This unit is classified as a CLASS
1 LASER product.
The CLASS 1 LASER PRODUCT
label is located on the rear exterior.
(Europe and U.K. model only)
Laser Diode Properties
•
Material: GaAlAs
• Wavelength: 780nm
•
Emission Duration: continuous
• Laser Output: max. 44.6µW*
* This output is the value measured at a distance of about 200mm
from the objective lens surface on the Optical Pick-up Block.
The apparatus is not disconnected from the AC power
source as long as it is connected to the wall outlet, even if
the apparatus itself is turned off.
1 cm 1 cm 10 cm 10 cm
10 cm
10 cm 10 cm
10 cm
Setup examples
Place this system as illustrated on the left and allow spaces
more than indicated around the system and more than 10 cm
(3-15/16”) behind the system to assure good ventilation. Be
sure not to place another unit or any object on top of the
receiver (RX-S75) to prevent the ventilation holes on the top
panel of the receiver from being obstructed. Otherwise, it
may cause fire or damage to the receiver.
Notes
•
When placing the speakers apart from the main units,
allow a space of at least 10 cm (3-15/16”) from above,
behind and on the both sides of the main units.
•
If the system is put in a rack, the front of it must be fully
opened.
•
Disconnect the AC supply lead from the AC outlet before
connecting or disconnecting any component.
VOLTAGE SELECTOR (General model only)
The voltage selector on the rear panel of this unit must
be set for your local main voltage BEFORE plugging
into the AC main supply.
Voltages are 110/120/220/240V AC, 50/60 Hz.
RX-S75 CDC-S75 KXW-S75
RX-S75
CDC-S75
KXW-S75