Yamaha CC-75 - Manual (Page 33)

E-25
English
RECEIVING RDS STATIONS
<
U.K. and Europe models only
>
Other functions which make use
of RDS data service
This unit has the following functions which make use of RDS
data service. These are originally in operation [ON].
However, you can cancel these functions [OFF], if so
desired.
➀
ON (OFF) CT
>
CLOCK
This unit corrects the time of the built-in clock
automatically by synchronizing it with the CT data on the
RDS station being received.
* If you receive an RDS station of some other country,
the built-in clock is synchronized with the time setting
of the country.
* If the built-in clock is not yet set for current time or
reset due to a power failure etc., it will be set for the
time of the CT data automatically, whether this setting
is ON or OFF.
➁
ON (OFF) LOCAL
>
CT
If the RDS station being received employs the local time
(summer time etc.) data service, its time is displayed in
the CT mode.
* If the setting of function
➀
is “ON”, the built-in clock is
synchronized with the local time data.
➂
ON (OFF) A. M.
>
RDS
Only RDS stations are programmed onto the area for FM
stations by the automatic preset tuning operation when
the setting is ON.
(See page 21 for the operating procedure.)
If you switch this function OFF, not only RDS stations but
also other FM stations are programmed along with MW
and LW stations by the automatic preset tuning
operation.
To switch these functions on and off
1
Select the FM band by pressing the BAND button,
watching the display.
2
Press the DISPLAY button to display the current time.
3
Press the RDS MODE selector button.
The title of function
➀
“ON CT
>
CLOCK ” is displayed.
4
Select the title of function whose setting you want to
switch by pressing the PTY SEEK MODE button once or
more.
5
Switch the function ON or OFF by pressing the PTY SEEK
START button, watching the display.
6
Press the RDS MODE selector button again to restore the
frequency display mode.
* If the station has PS data, after that, it turns into the PS
mode.
Notes
• Once the setting is changed, it will be stored until it is
changed again by the above operation.
• During the operation, if there is no operation for about 20
seconds, this mode is canceled and turns into the
frequency display.
If the station has PS data, after that, it turns into the PS
mode.
Receiver
3, 6 4
2 1 5
1
2
3
PTY SEEK
MODE