ZyXEL Communications MES-2110 - Manual (Page 182)

Chapter 23 Command Line Interface
MES-2110 User’s Guide
182
23.5 Basic Commands
Basic commands are in all modes.
When in Basic mode, the command prompt is as follows:
.
The following is a list of available Basic commands:
MES-2110>
Table 77 Basic Commands
COMMAND DESCRIPTION
exit
In Basic mode, this disconnects you from the
device (identical to logout).
In other modes (such as Privileged), this returns
you to the previous mode.
help
Lists available commands.
history
Displays a list of previously run commands.
logout
Disconnects from the device.
ping <-n count> <-l length> <-t> <-w
timeout> <ip-address>
Pings the specied IP address.
You can use the following parameters:
-n count
: Determines the number of echo
requests to send. The default is 4.
-l length
: Adjusts the size of the ping packet
by the number of specified bytes (64~8148).
-t
: Pings the specified host until the break
(ESC) key is pressed.
-w timeout
: Adjusts the timeout duration for
the ping packet in milliseconds. The default is
1,000 milliseconds.
show ip
Displays the device’s network configuration.
show system-information
Shows the device’s system configuration.