ZyXEL Communications MES-2110 - Manual (Page 56)

Chapter 5 The Web Configurator
MES-2110 User’s Guide
56
The following table describes the links in the navigation panel.
DHCP Snooping
DHCP Snooping Config
DHCP Binding Table
ARP Inspection
MAC Menu
MAC Table Status
Lock Learning MAC
MAC Filter Config
MAC Limit Config
QoS Menu
Base Configuration
802.1p Priority
Tag Priority
IP DSCP Priority
Priority Override Configuration
Table 6 Navigation Panel Links
LINK DESCRIPTION
System Details
System
Info.
This link takes you to a screen that displays general system information.
You can also configure general system information about the MES-2110.
Board Info. This link takes you to a screen that shows hardware and firmware
information.
DHCP
Config
This link takes you to a screen where you can configure the DHCP
settings.
Configuration
Port
Configurati
on
This link takes you to a screen where you can configure settings for
individual MES-2110 ports.
Port Status This link takes you to a screen that shows port settings for individual
MES-2110 ports.
Rmon
Status
This link takes you to a screen where you can view statistics on the
traffic going through each port.
Loop
Detection
This link takes you to a screen where you can configure protection
against network loops that occur on the edge of your network.
Jumbo
Frame
This link takes you to a screen where you can configure Jumbo frames or
Ethernet frames with a payload greater than 1500 bytes.Use this screen
to configure the jumbo frame size.
802.1x This link takes you to a screen where you can configure IEEE 802.1x
authentication.
Bridge
Menu
This link takes you to screens where you can configure the RSTP to
prevent network loops.
VLAN Menu This link takes you to screens where you can configure port-based or
tag-based (802.1Q) VLAN (depending on what you configured in the
Switch Setup menu).