ZETA Music Systems ZMC-200 - Manual (Page 13)

8
ZETA Music Systems, Inc.
ZMC-200 Manual Rev2.0
9. Press the +Parameter button. “DYNAMIC CONTR1”
10. Press “Enter.” Set to “Volume 7.”
11. Press the +Parameter button. Set “INTENSITY” to “0.”
12. Press “Exit” three times.
13. Press the +Parameter button to “STRING MODE.” Using
the +/- Value buttons set to “Sep.”
14. Press the +Parameter button to “WHEELCNTL.” Press
“ENTER”
15. Using the +/- Value buttons set to “NO CONTROLLER”
16. Press the EXIT button. Press the EDIT button. to get back
to the top of the Preset area. We now want to give our new
(changed) preset a new name. Press the +PARAMETER
button. Press the ENTER button. The editor cursor is now
over the ”E” of the old name ”EPno2+HdPad.” With the +/-
Value buttons you can change the letter where the cursor is.
Think of a new name and change the first letter accordingly.
With the +/- Parameter buttons you can move the editor
cursor one character to the right or to the left respectively.
Repeat this process until your new name is complete in the
display. If your new name is shorter than the old one, you can
simply change the left over letters to spaces.
17. Press the EXIT button twice to end your Preset text
editing session. The upper half of the display is blinking.
This signals that you have changed some parameters that
have not yet been saved. Press the STORE button. Now you
can determine at which slot you want to save your new
Preset. You can either overwrite the Preset you have been
editing or save it at another location within the user-definable
area (1-128). Choose, for example, Preset No. 128 (+/- Value
buttons). Now when you press the ENTER button, your
preset will be copied to slot 128 and saved there. This also
now becomes the active preset.