ZETA Music Systems ZMC-200 - Manual (Page 30)

25
ZETA Music Systems, Inc.
ZMC-200 Manual Rev2.0
The cursor is in the first line and by using the +/- Value buttons, you can
select the controller you want to work with. The + Parameter button moves
the cursor to the second line, and then the default value can be changed
using the +/- Value buttons. The value you enter here will be saved in a
battery-backed-up memory area of your ZETA SYNTHONY II. The table
contains the factory default values. All standardized MIDI controllers have
a default value of zero. Refer to the user manual of MIDI instrument or
module you are using for the default values of any controller used by the
manufacturer and set it here. Use the EXIT button to leave the Submenu.
MIDI MAPPING:
Program change commands that are received on the selected active
BASIC CHANNEL can be assigned to any ZETA SYNTHONY II presets
using this mapping table. Press the ENTER button. The first line of the
display shows the program number that your ZETA SYNTHONY II
receives; the second line of the display shows the Preset to which the
change will be made. The default setting is the program change will be sent
to the ZETA SYNTHONY II preset with the same program number. If you
want to change this setting, use the +/- VALUE buttons to change to the
appropriate value. Your entry will be immediately saved in the ZETA
SYNTHONY II’s internal battery-backed-up memory, and does not have to
be saved. Use the EXIT button to leave the submenu.