ZETA Music Systems ZMC-200 - Manual (Page 40)

35
ZETA Music Systems, Inc.
ZMC-200 Manual Rev2.0
ASSIGN allows for playback of notes in the same order in which
they were recorded. REVERS acts like a stack of notes where the
last one recorded is the first one replayed. The arpeggiator plays
the notes in reverse order than they were entered. RECYCLE plays
the arpeggiator sequence in normal order as with ASSIGN, but
when the end of the sequence is reached, it is played back in
reverse order as with REVERS until the first note in the sequence
is reached, at which point the process begins from the beginning
again. In UP mode, the notes will be sorted from lowest to highest
in pitch and played in that order. In DOWN mode, the notes are
sorted from highest to lowest in pitch and played in that order. In
UP/DOWN mode, the pitches are played from lowest to highest
and then back down to lowest, somewhat simulating finger
picking. RAND plays back the notes of the arpeggiator sequence in
total random order.
PATTERN
(1/16thSt…USER#1…16)
This parameter allows you to set the quantize function of the arpeggiator
sequence. The following quantize functions are available:
1/16thSt:
Classic Arpeggio. Plays back the arpeggiator sequence in staccato 16th
notes.
1/16thLg:
16th notes same as above except legato.
1/8thSt:
Plays back the arpeggiator sequence in staccato 8th notes.
1/8thLg:
8th notes same as above except legato.
1/4thSt:
Plays back the arpeggiator sequence in staccato quarter notes.
1/4thLg:
Quarter notes same as above except legato.
1/2th:
Plays back the arpeggiator sequence in quarter note values with quarter
rests.
1/8Trpl:
Plays back the arpeggiator sequence in 8th note triplets.