ZyXEL Communications 2000W - Manual (Page 6)

Prestige 2000W Quick Start Guide
6
2.3 Text Input
3 Initial Configuration
Use the LCD screen menu system for initial configuration to make calls. Your service provider may have
already configured the settings for you.
Note: If your main screen already displays Registered, skip to Section 4 on page 17 .
3.1 Wireless LAN Setup
When you turn the Prestige on, it searches for available wireless LAN Access Points (APs). It selects the AP
with the best signal and restarts and attempts to connect to it.
Use the following if you want to select a specific AP or enter a WEP key.
3.1.1 Site Survey
Do the following to browse the networks available in your area and select one.
• When you need to enter text or numbers in a screen, use the Off key to clear the
default text or backspace.
• Use the up and down arrows to select the type of characters (capital letters, lower-
case letters, numbers or symbols).
WEP key 1
**********
Ok Aa1@ Clear
1 Select Wireless in the first menu screen (use the up or down arrow to highlight
it and then press the Left key).
8. Restart
1. Information
Select Back
2 Select Site Survey.
3 The Prestige checks for and displays a list of available APs.
2. SSID
3. Network Mode
Select Back
4 The AP’s SSID is followed by a number describing its relative signal strength.
The higher the number, the better the signal. Select an AP to use.
5 Stay in the Wireless menu and continue with the next section.
AP2 90
AP3 85
Select Back
7. Wireless
1. Site Survey
AP1 99
VoIPon Solutions www.voipon.co.uk [email protected] Tel: +44 (0) 1245 600560