Zenith HEALTHVIEW H20J55DT - Manual (Page 53)

Page 53 206-4065
LT2002 QuickSet Programmer
Cloning Preparations
Before You Begin Cloning...
• Only use one MPI port for connecting
to MPI equipment.
• Do not run Auto Program while TV is
connected to clone programmer.
• The “master TV” should be connected
to a good, stable signal from an over-
the-air antenna or cable service and
turned on.
• Teaching and Learning is only possi-
ble between identical
model Zenith
TV's. (However, the Clone programmer
can store 3 different master TV setups.)
WARNING: Copying a blank or incorrect
memory into a TV will cause
the TV to operate erratically or
become inoperable.
• Use a typical Zenith HealthView
Installer remote or the Installer remote
shown on page 16 to operate Learning
and Teaching menus.
• Make sure that the batteries in the
Clone programmer are fresh.
• If the batteries are removed, the Clone
Clock time will be lost.
• Decide if you want to set the time
from the Clone programmer or copy the
time to the Clone programmer; from a
TV which has the clock set to the cur-
rent time.
• Follow the connection diagrams on
the previous page to connect the Clone
to a master TV and, after learning is
complete, to another TV to “teach” it
the setup.
• Setting the time and transferring it
to the Clone or another TV is a separate
procedure.
• Once a TV’s setup is copied to anoth-
er TV, the target TV needs to be discon-
nected from power for about 15 sec-
onds to
activate the newly-copied
setup.
• See Troubleshooting to solve prob-
lems.
A. Set Up a Master TV
Using the installer remote shown on
page 16, set up a “Master” TV with cus-
tom settings and features as described
in the TV’s operating guide.
The master TV’s Setup is what you will
copy to the Clone Programmer and
transfer to TV's with the same model
number so they will operate identically.
B. Connect Clone to Master TV
If there is a good connection, the
“Clone has Control of the TV” message
will appear on the TV screen. ( See
menu on the previous page.)
Cloning capability of a Master TV setup is restricted to channels displayed in
Physical channel scanning mode. For Physical Channel Scan, leave Installer
A slow flashing green light indicates there is a problem with the communica-
tions between the TV and the programmer. In this case, check for a damaged
cable, poor contacts or other connection troubles.
If the status indicator is red, the programmer batteries are low and should be
replaced. Use 4 good-quality alkaline AA batteries.
Menu item 103-IATSC Tune Mode set to 1 (see Installer Menu pages 44 and 50).