Zebra Technologies LI 72 - Manual (Page 25)

25
RW 420 User Guide
Wireless Local Area Network (WLAN) Module Using CF Radio
The following section only applies when the CF (Compact Flash) WLAN module (With
FCC ID: I28MD-RW4137) is installed in a RW 420 printer (note that only one of the radio
options can be installed in the printer at one time). The FCC ID number is on the serial
number label on the back of the printer and can be read with the module installed.
WARNING: Use of a RW 420 printer with the radio module
marked with “FCC ID: I28MD-RW4137” meets the FCC
requirements for radio frequency (RF) radiation exposure in the
standard body worn configuration with no minimum separation.
In this configuration, which applies whether the belt clip or
shoulder strap is used, the face of the printer from which paper
is transported is facing away from the user’s body. The standard
configuration must always be used when the printer is body
worn.
RW 420 printers with this radio option have been SAR tested.
The maximum SAR value measured for each model was T. B.D.
W/kg averaged over 1 gram.
European Regulatory Information for this Radio
AT BE CY CZ DK
EE FI FR DE GR
HU IE IT LV LT
LU MT NL PL PT
SK SI ES SE GB
Note: -Member states in the EU with restrictive use for this device are crossed
out!
This device is also authorized for use in all EFTA member states (
CH, IS, LI, NO)
0336
Important Notice:
This device is a portable RF printer intended
for commercial and industrial use in all EU and
EFTA member states except in France where
restrictive use applies.