Zebra Technologies LI 72 - Manual (Page 30)

30
RW 420 User Guide
The MSR is used as follows:
1. When the reader is enabled, place the card into the
reader slot as shown. The magnetic stripe (typically on
the back of the card) must face the bottom of the printer,
and be inserted into the bottom of the card reader slot as
shown in Figure 15.
2. Slide the card through the slot. The card will be read
if slid in either direction. Depending on the application
software, the printer will sound one chime when a scan is
successful .
3. If the card did not read, slide it back through the slot in
the opposite direction.
Figure 15: Using the Magnetic Stripe Reader
Magnetic Stripe Card
Place the Card in the reader slot with the mag-
netic stripe facing down as shown.
Card can be read in
both directions.
Magnetic Stripe
Reader Slot