Zoom DUALCAM 300 - Manual (Page 2)

2
Zoom DualCam 300 Digital Camera
Congratulations on purchasing the Zoom DualCam 300. This manual introduces
you to the camera and tells you how to install its software.
To set up your camera or change a setting, depress the power button and hold it
down until the camera beeps indicating that the power is on. Pressing the
Menu/Power button again will cycle through the menu of icons on the LCD
display. When you want to change a setting, depress the Shutter/Confirm
button while the appropriate icon is flashing. The menu options will cycle in a
loop starting with the Timer and working counter-clockwise.
LCD display:
Below is the description for each icon on the LCD panel.
Self-timer:
Self-timer allows you to delay approximately 10 seconds
before the shot is taken.
Continuous snapshot:
A single click on the capture button will cause the camera to
take 3 pictures (one picture per second).
Hi/Lo:
The LO icon indicates that the camera is in the low-
resolution mode. If there is no icon, the camera is in high-
resolution (Hi) mode (VGA 640x480). Your camera must be
in high-resolution mode to utilize the 1.3 meg (1280x960)
resolution, which is achieved through software interpolation
.
AVI:
Auto Video mode. The frame rate is about 9 frames per
second for all resolutions.
Battery status detection:
A 3-segment battery icon is displayed to indicate the
condition of the battery. Please see the Batteries section for
details.