Zoom DUALCAM 300 - Manual (Page 3)

3
50/60:
50 for 50Hz electrical power frequency, 60 for 60Hz electrical
power frequency. Set this according to the country you are in
to eliminate flickering in your pictures when under
fluorescent lights.
Delete last/all:
If the icon is selected, the last picture taken will be
erased when the Shutter/Confirm button is pressed.
If the icon is selected, all pictures stored in the
memory will be erased when the Shutter/Confirm button is
pressed.
Picture number, PC, Memory_full:
When the camera is not attached to the computer, this will
indicate how many pictures you have taken. When the
camera is attached to the computer and in PC mode, the PC
icon displays instead. When the memory is full in detached
mode, the display reads FUL and the alarm sounds.
Software Installation
1. IMPORTANT Do not connect the camera to your computer before the
software is completely installed, because it may result in the PC not starting
correctly. If this problem occurs, power down the PC, unplug the camera,
and restart the PC.
2. Put the Zoom DualCam 300 CD into your CD-ROM drive. Your computer
will automatically run the software. Note: If the software does not set up
automatically, go to the Taskbar and click Start, then click on Run, select
Browse, choose SETUP.EXE on the software CD, then click OK to install.
3. Using the pull-down menu, select the language you want, then click OK.
Follow the on-screen instructions to install the ArcSoft Software Suite.
4. After the application has been installed, the software automatically starts the
camera driver Installation program. Follow the on-screen instructions.
5. If you selected to install the VideoImpressions software, the install
program prompts you to install DirectX. Follow the on-screen instructions.
6. Click the Finish icon and restart your computer after completing the
installation of the application software, the camera driver, and DirectX.
(When you attach the camera to the computer, Windows will detect it and
complete the installation automatically.)
Connecting the DualCam 300 to the Computer’s USB port
1. Connect the USB cable to your computer’s USB port.
2. Connect the USB cable to your Zoom DualCam 300.