This parameter is used to specify whether shelving or peaking equalization is to be
applied within the two end bands — namely, Low and High. It is available only when
MEQ has been set to “Low” or “High”.
Setting values: shelv (Shelving EQ), peak (Peaking EQ)
shelv

Signals at all frequencies either above (“High”) or below (“Low”) the specified frequency
will be uniformly boosted or cut.

peak

Signals within a band of frequencies around the specified frequency will be boosted or cut
in a localized fashion.

Gain

This parameter is used to specify how much signal levels in the vicinity of the fre-
quency set using the Freq parameter will be boosted or cut. Gain levels for the indi-
vidual frequency bands can also be set using the [MASTER EQUALIZER] knobs on
the control panel.
Setting values: -12dB to +12dB

0 (10)

Freq (Frequency)

This parameter is used to set the central frequency around which levels will be cut or
boosted.
Setting values:
Low

When Shape is set to “shelv”: 32Hz to 2.0kHz

When Shape is set to “peak”: 63Hz to 2.0kHz

LowMid, Mid, and HighMid

100Hz to 10.0kHz

High

500Hz to 16.0kHz

Q (Resonance)

This parameter is used to create a range of different frequency-curve characteristics
in the vicinity of the frequency set using the Freq parameter. If you set a large value,
a narrower band of frequencies will be boosted or cut, and the tone will change
markedly around the center frequency. If you set a smaller value, a wider band of fre-
quencies will be boosted or cut, and the tone will change more gradually around the
center frequency.
Setting values: 0.1 to 12.0

NOTE

The Q parameter is unavailable for the Low and High bands when their respective
Shape parameters have been set to “shelv”.

Page

On-screen name

(and full name)

Description

–

EQ Low

EQ High

Frequency

Gain

Frequency

Gain

–

Frequency

Gain

–

0.1

12.0

Frequency

Advertising

This manual is related to the following products:

CP50

Popular Brands

Popular manuals